Home / Electricity & Magnetism / RC Circuit

RC Circuit: Capacitor Charging & Discharging

NEETJEECBSE
V_C: 0 V I: 0 mA Time constant ฯ„: 0 s Elapsed: 0 s

The physics

When a capacitor charges through a resistor, current doesn't jump instantly to its final value, and voltage doesn't rise instantly either โ€” both change smoothly, following an exponential curve governed by a single characteristic time, the time constant ฯ„.

Charging: V_C(t) = Vโ‚€(1 โˆ’ e^(โˆ’t/ฯ„))   I(t) = (Vโ‚€/R)e^(โˆ’t/ฯ„)
Discharging: V_C(t) = Vโ‚€e^(โˆ’t/ฯ„)   I(t) = (Vโ‚€/R)e^(โˆ’t/ฯ„)
Time constant: ฯ„ = RC

At exactly t=ฯ„, a charging capacitor reaches 63.2% of Vโ‚€ โ€” never a clean, memorable fraction like half or a quarter, simply because eโปยนโ‰ˆ0.368 is where the math lands. After 5ฯ„, the capacitor is over 99% charged, which is why "5 time constants" is the standard engineering rule of thumb for "essentially fully charged."

Exam tip: a very common NEET/JEE trap asks for the current at the exact instant a fully-discharged capacitor is connected (t=0) โ€” at that instant the capacitor behaves like a plain wire (short circuit, zero resistance), so I(0)=Vโ‚€/R exactly, with the capacitor contributing no resistance at all. Conversely, once fully charged (tโ†’โˆž), the capacitor behaves like an open switch, blocking all further current.

Sample data: charging a capacitor through a resistor

V_C = Vโ‚€(1 โˆ’ e^(โˆ’t/ฯ„)) and I = (Vโ‚€/R)e^(โˆ’t/ฯ„), with ฯ„ = RC.

TimeCapacitor voltagePercentage of battery voltageCurrent
1ฯ„ = 1 s7.59 V63.2 %0.441 mA
2ฯ„ = 2 s10.38 V86.5 %0.162 mA
3ฯ„ = 3 s11.40 V95.0 %0.060 mA
5ฯ„ = 5 s11.92 V99.3 %0.008 mA

Conditions: R = 10 kฮฉ, C = 100 ฮผF, Vโ‚€ = 12 V, so ฯ„ = 1 s.

Notice: after one time constant (1 s) the capacitor has only 63.2% of the battery voltage, and after 5ฯ„ it has 99.3%. At the end the capacitor stores ยฝCVโ‚€ยฒ = 7.2 mJ, but the battery has supplied QVโ‚€ = 14.4 mJ. The other half, 7.2 mJ, was dissipated as heat in the resistor, no matter what its value was.

๐ŸŽฏ Practice Zone

Puzzle 1. โšก At the exact instant a battery is first connected to an uncharged capacitor through a resistor, the current is at its absolute MAXIMUM value โ€” yet a fully charged capacitor blocks current entirely. Why does the current start high and then decay, rather than starting at zero and building up?

At the very first instant, the capacitor holds zero charge and therefore zero voltage across it โ€” this means the ENTIRE battery voltage Vโ‚€ appears across the resistor alone, driving the maximum possible current Iโ‚€=Vโ‚€/R through the circuit at that moment, exactly as if the capacitor weren't there at all. As charge accumulates on the capacitor, its own voltage rises, leaving progressively LESS voltage available across the resistor to drive current โ€” current therefore decreases continuously as charging proceeds, reaching zero only once the capacitor's voltage equals the full battery voltage and no further charge flow is needed.

Puzzle 2. โฑ๏ธ Doubling the resistance R in an RC circuit doubles the time constant ฯ„, making charging take twice as long โ€” yet doubling R also HALVES the maximum current that ever flows. How can a circuit take longer to charge while simultaneously carrying less current throughout?

These two effects aren't actually in tension โ€” they're both direct, consistent consequences of the resistor limiting current flow more strongly. A larger resistance genuinely does reduce the instantaneous current at every moment (Iโ‚€=Vโ‚€/R is smaller), meaning charge accumulates on the capacitor more slowly โ€” and since the SAME total charge (Q=CVโ‚€) still needs to accumulate to reach full charge, delivering that charge more slowly naturally takes proportionally longer. Both the slower current and the longer time are simply two views of the same underlying fact: a bigger resistor throttles the rate of charge delivery.

Puzzle 3. ๐Ÿ”‹ A camera flash uses exactly this kind of RC circuit โ€” slowly charging a capacitor from the battery over a second or two, then discharging it almost instantly through the flash bulb. Why does a camera flash need a capacitor at all, rather than just connecting the flash bulb directly to the battery?

A camera's small battery simply cannot supply the enormous burst of current a bright flash bulb needs, fast enough, directly โ€” batteries are generally better suited to delivering modest current steadily over a longer time, not an intense momentary surge. The capacitor solves this mismatch elegantly: it charges up slowly and gently from the battery (drawing only modest current over a second or two, well within the battery's comfortable capability), then discharges nearly all its stored energy almost instantly through the flash bulb when triggered โ€” delivering the intense momentary power burst the flash genuinely needs, using energy that was patiently accumulated beforehand rather than demanded from the battery all at once.

Puzzle 4. ๐ŸŒŠ A capacitor charging through a resistor never mathematically reaches EXACTLY Vโ‚€ in any finite time โ€” the exponential formula only approaches it asymptotically, technically requiring infinite time for perfect completion. Does this mean real capacitors, in real circuits, genuinely never finish charging?

Mathematically, yes โ€” the exponential charging curve technically never reaches exactly Vโ‚€ in finite time, always leaving some vanishingly tiny remaining gap. Physically, though, this remaining difference becomes so astronomically small after just a handful of time constants (about 1% remaining after 5ฯ„, under 0.005% remaining after 10ฯ„) that it becomes completely unmeasurable and irrelevant for any practical purpose โ€” indistinguishable from "fully charged" by any real voltmeter or downstream circuit. This is precisely the same "approaches but never mathematically reaches" pattern seen in Newton's law of cooling โ€” a genuinely common feature of exponential processes throughout physics.

Puzzle 5. ๐Ÿ’ก A "flickering candle" LED effect and various timing circuits (old-style camera self-timers, simple oscillators) are often built around nothing more than a resistor, capacitor, and a threshold-triggered switch. How does the smooth, predictable exponential RC charging curve become the basis for creating a specific, adjustable TIME DELAY?

Since the exact time needed to reach any particular fraction of Vโ‚€ depends precisely and predictably on ฯ„=RC, engineers can choose specific R and C values to create almost any desired delay โ€” a switch or trigger circuit set to activate once the capacitor voltage crosses some fixed threshold (say, 50% or 70% of Vโ‚€) will fire after a reliably calculable, adjustable time delay. This exact principle โ€” using RC charging time as a controllable "timer" โ€” underlies countless simple timing circuits, from an old camera's self-timer delay to basic blinking-LED novelty circuits, all without needing any digital clock or microcontroller at all.

Problem 1 (NEET level). ๐Ÿ“˜ A circuit has R=1000ฮฉ and C=1000ยตF. Find the time constant ฯ„.

ฯ„ = RC = 1000 ร— 1000ร—10โปโถ
ฯ„ = 1 second

Problem 2 (JEE Main level). ๐Ÿ“— For the same circuit with Vโ‚€=10V, find the capacitor voltage at exactly t=ฯ„ during charging.

V_C(ฯ„) = Vโ‚€(1โˆ’eโปยน) = 10 ร— (1โˆ’0.368)
V_C(ฯ„) = 6.32 V (63.2% of Vโ‚€, exactly as the physics section states)

Problem 3 (WBJEE level). ๐Ÿ“™ Find the initial current Iโ‚€ (at t=0) for the same circuit, and the current remaining at t=ฯ„.

Iโ‚€ = Vโ‚€/R = 10/1000 = 0.01 A (10 mA)
I(ฯ„) = Iโ‚€ร—eโปยน = 0.01ร—0.368 = 3.68 mA (36.8% of Iโ‚€ remains)

Problem 4 (CBSE Class 12 level). ๐Ÿ“• A fully-charged 10V capacitor (C=1000ยตF) begins discharging through R=1000ฮฉ. Find its voltage at t=2ฯ„.

V_C(2ฯ„) = Vโ‚€ร—eโปยฒ = 10 ร— 0.1353
V_C(2ฯ„) = 1.35 V (about 13.5% of the original voltage remains)

Problem 5 (JEE Advanced style). ๐Ÿ““ Find how many time constants (as a multiple of ฯ„) are needed for a charging capacitor to reach exactly 90% of Vโ‚€, using V_C=Vโ‚€(1โˆ’e^(โˆ’t/ฯ„)).

0.90 = 1โˆ’e^(โˆ’t/ฯ„)
e^(โˆ’t/ฯ„) = 0.10
โˆ’t/ฯ„ = ln(0.10) = โˆ’2.303
t = 2.303ฯ„ โ€” confirming the common engineering shorthand that roughly "2.3 time constants" reaches 90% charge, distinct from the "5 time constants for ~99%" rule of thumb
โšก
1745โ€“1746

The Leyden jar, one of the earliest practical capacitors, is independently developed โ€” allowing electrical charge to be stored for the first time, though the precise mathematics of charging and discharging through a resistance wouldn't be understood for another century.

๐Ÿ”ฌ
1850sโ€“1860s

Lord Kelvin and other telegraph engineers studied the exponential charging behavior of long submarine telegraph cables (which behave like enormous distributed RC circuits), work directly motivated by the practical need to understand and minimize signal delay across the first transatlantic telegraph cables.

๐Ÿ“ป
Early 1900s

As radio and early electronics developed, RC timing circuits became a standard, essential building block for creating controlled time delays in countless devices, exploiting the precise, predictable mathematics of exponential charging established decades earlier.

๐Ÿ’ป
Present day

RC charging and discharging behavior remains fundamental to modern electronics โ€” from camera flash circuits, to the precise timing of digital clock signals in computer processors, to designing filters that separate different frequency signals, all directly built on the same exponential mathematics explored in this simulation.